- Pick a place on your jeans above the hemline. If your jeans
are too long to get a snug fit, cuff them 1” at a time until you have the desired length (see image). Be sure to pick an area above the hemline or cuff so the smaller part of the metal frame only comes in contact with one layer of denim. - Open the garter clip and place the garter tab (the white,
rubber piece) inside your jean and the metal frame on the outside. - Align the garter tab with the center of the large part of the
frame. While holding the garter tab, pull the metal frame in the
opposite direction and guide the garter tab into the smaller part
of the frame. Depending on the thickness of your denim, this may
take a little more or less pressure. - Repeat on the other side.